Shinloneis capable of manufacturing custom hydroforming die. Hydraulic form dies are used in reconfiguring the original shape of a given case from a standard common caliber into calibers such as the Ackley Improved calibers, 6mm Dasher, 6XC and other nonstandard wildcat calibers. The hydraulic form die is also used on cartridges that are blown out or have a sharper shoulder angle than the parent case. Shinlonehas the capability to manufacture almost any caliber die you need.
Just as with our custom die sets, there are a couple of methods used to manufacture the hydroforming die you need. If possible, send the schematic print of the reamer used to cut the chamber in your rifle. If that is not readily available, send three (3) unsized fired cases from the rifle and these can be used as well, or you can do both. Should you send fired cases, an average measurement of the cases will be used to cut the hydraulic die.